How to use › SDS
Nanocyn Advanced is a hospital-grade surface cleaner, sanitiser and disinfectant. Here are the key facts from its Safety Data Sheet, in plain English.
Download SDS (PDF)
About the product
A water based solution of neutral oxidised saline containing available chlorine at 0.026% w/w, which is 260 ppm. Water makes up the balance of the formula.
It is not classified as hazardous under the model WHS Regulations and GHS, has no signal word, hazard statements or pictograms, and is listed on the ARTG. Recommended use: hospital-grade surface cleaner, sanitiser and disinfectant, used only as directed on the product label.
Key facts
pH
Neutral
Appearance
Clear, colourless liquid
Odour
Minimal, faint chlorine odour
Flammability
Will not burn. No flash point.
Poisons standard
Not a scheduled poison under the SUSMP
Transport
Not a Dangerous Good under the ADG Code, IATA or IMDG
Relative density 1.0 (water = 1). Fully soluble in water.
Care and handling
First aid
The SDS notes that the product is not known to cause eye, skin, breathing or ingestion problems. If any of these happen:
If eyes become irritated, hold eyelids apart and flush with plenty of water for at least 15 minutes. Seek medical attention if irritation develops or persists.
If skin becomes irritated, wash with plenty of soap and water and remove contaminated clothing and shoes. Seek medical attention if irritation worsens or persists.
If breathing is difficult, move to fresh air. Seek medical attention if a cough or other symptoms develop.
If swallowed, drink plenty of water. Seek medical attention if gastric distress develops.
Australian Poisons Information Centre 13 11 26, 24 hours
This page is a plain English summary. The Safety Data Sheet is the full reference.
Download SDS (PDF)Always read the label and use as directed.